CLI Guide
Table 4. racadm arp (continued)
Address HWtype HWaddress Flags Mask Iface
192.168.1.120 ether 90:b1:1c:f4:32:09 C pub
192.168.0.121 ether 90:b1:1c:f4:34:f4 C pub
chassisaction
Description Runs the turn on, turn off, power cycle, or reset operation.
Synopsis
racadm chassisaction [-m <module>] <action>
Input
● -m—Must be one of the following values:
○ chassis—Default state if -m is not specified.
○ switch-<n>—Where n =1-6
● <action>—Must be one of the following values:
○ powerdown—Graceful shutdown of the module
○ powerup—Turns on the module
○ powercycle—Graceful restart of the module
○ nongraceshutdown—Nongraceful shutdown of the module
○ reset—Hard reset of the module
NOTE: The valid option for <module = switch> is reset.
Example
● Perform a reset of switch-2
racadm chassisaction -m switch-2 reset
● Perform a non-graceful shutdown of the chassis
racadm chassisaction -m chassis nongraceshutdown
chassisgroup
Description
Approves or rejects the chassis addition requests. You can also use this command to view the chassis
group details. Supported options are:
● racadm chassisgroup help add
● racadm chassisgroup help view
● racadm chassisgroup help admit
● racadm chassisgroup help deny
Synopsis
racadm chassisgroup <chassisgroup command type>
Input
● -m—IPv4 address of stand-alone chassis
● -l—IPv4 address of leader chassis
● -g—Name of the chassis group
● --pending— Pending requests to join the group
● --discovered— Discovered chassis in the wired environment
RACADM sub command details 11