CLI Guide

cmcchangeover
Description Changes the redundant state of the management module from active to standby and standby to active.
Synopsis
racadm cmcchangeover
Input racadm cmcchangeover
Example NA
NOTE: During a failover, the chassis power state on the OME - Modular GUI is displayed as "off". The original power state
is displayed after the inventory is refreshed.
config
Description Modifies the configuration properties of the management module.
NOTE: Use racadm config command to set basic attributes such as IP address attributes, to
access the system. To configure complex or multiple networking attributes such as DNS registration
attributes use the RESTful API or OME-Modular web interface. The racadm interface does not
facilitate setting multiple dependent attributes in a single call.
Synopsis
racadm config -g <group> -o <object> <value> [-m <module>]
racadm config -g <group> -i <index> -o <object> <value>
Input
● -g—Configuration group to which the object belongs
● -o—Configuration object to configure
● -i—Index of indexed group, which is used with -g and -o
● -m—The module must have one of the following values: - storage-<n>- where n=1 to 8
NOTE: The storage -<n> option is available only for cfgStorageModule
● <value>—Value of the configuration object
Example
● Configure a single property of a group:
racadm config -g cfgLanNetworking -o cfgDNSRacName NAME
● Configure a single property of a group for a particular user:
racadm config -g cfgUserAdmin -i 2 -o cfgUserAdminPassword PASSWORD
connect
Description
Connects to switch or blade serial console. The connect command is supported only on firmware
interfaces.
NOTE: To terminate racadm connect command, use control+\(backslash).
NOTE: You can connect eight serial sessions simultaneously for compute sleds using racadm
connect command.
Synopsis
racadm connect [-b] -m <module>
14 RACADM sub command details