CLI Guide

Input

● -b—Binary mode

If -b is used, reset OME-Modular to terminate the connect.

● -m—The <module> option must be one of the following values:

○ server-<n>—where n = 1-8

○ switch-<n>—where n = 1-6

CAUTION: When run from the OME–Modular serial console, the connect -b option stays

connected until the management module resets or the serial console is terminated. This

connection is a potential security risk.

NOTE: The racadm connect to server prompts you to enter the iDRAC credentials for connecting

to the server.

Example

● Connect to server 1 serial console:

racadm connect -m server-1

● Connect to I/O module 1 serial console:

racadm connect -m switch-1

NOTE: When you run the racadm connect -m switch-<N> command for the first time, the

option to enter the user credentials is not displayed. Press Enter again to view the option to enter

the user credentials.

NOTE: Use quit key that is configured on the iDRAC to quit the console.

NOTE: When you run the command, racadm connect -m switch-<N>, the first time, the option to enter the user

credentials is not displayed. Press [Enter] again to view the option to enter the user credentials.

deploy

Description

Deploys blade or IOM by specifying required properties.

In the firmware or SSH racadm interface, enter a backward slash before the string. For example: xyz

\^123. In remote racadm, enter the string in double quotes. For example: "xyz^123".

NOTE: The quick deploy command is not supported in RACADM.

Synopsis

racadm deploy -m server-<n> -u root -p <password> -s <ipaddress>

racadm deploy -m server-<n> -u root -p <password> -s -6 <ipv6Address>

racadm deploy -m server-<n> -u root -p <password> -d [-6]

racadm deploy -m switch-<n> -u root -p <password>

racadm deploy -m switch-<n> -v SNMPv2 <snmpCommunityString> ro

racadm deploy -a [server|switch] -u root -p <password>

NOTE: For IOMs, you can only configure SNMPv2 community strings.

RACADM sub command details 15