Users Guide

Figure 3. View Controller Information Screen
Changing the boot order of the virtual disks
Set Bootable Device allows you to change the boot order of the virtual disks.
1. Enter the Dell PERC S140 Configuration Utility. See Entering the DELL PERC S140 Configuration Utility on page 27.
2. Click Controller Management > Change Controller Properties.
3. Click Set Bootable Device.
A Change Order dialog box displays the list of virtual disks available.
4. Use the arrow keys to set a virtual disk and + or – to change the order of the virtual disks that need to be booted first.
5. Click Ok.
The changes to the boot order of the virtual disks are displayed.
Stopping the system from booting if there is a critical BIOS error
The Change Controller Properties screen allows you to either enable or disable the option to stop the system from booting if
there is any critical BIOS error requiring manual intervention.
1. Enter the Dell PERC S140 Configuration Utility. See Entering the DELL PERC S140 Configuration Utility on page 27.
2. Click Controller Management > Change Controller Properties.
3. You can either enable or disable the Enable BIOS Stop On Error.
Converting a physical disk to a Non-RAID disk
1. Enter the Dell PERC S140 Configuration Utility. See Entering the DELL PERC S140 Configuration Utility on page 27.
2. Click Controller Management > Convert to Non-RAID Disk.
3. Select the interface type.
4. Select the physical disks. Click Check All to select all the disks available.
UEFI RAID configuration utility
29