Users Guide

Table 7. Command description

Command Description

OS10# image install image-url

Example:

OS10# image install image://filename.bin

Install the software image.

f. (Optional) View the status of the current software install in EXEC mode.

Table 8. Command description

Command Description

OS10# show image status View the status of the current software install.

g. Change the next boot partition to the standby partition in EXEC mode. Use the active parameter to set the next boot

partition from standby to active.

Table 9. Command description

Command Description

OS10# boot system standby Change the next boot partition to standby.

h. (Optional) Check whether the next boot partition has changed to standby in EXEC mode.

Table 10. Command description

Command Description

OS10# show boot detail Check whether the next boot partition has changed.

i. Reload the new software image in EXEC mode.

Table 11. Command description

Command Description

OS10# reload Reload the new software.

j. After the installation is complete, enter the show version command to check if the latest version of the software that you

have installed is running in the system.

The example below shows that the 10.5.0.5 software is installed and running on the system.

OS10# show version

MX9116N-A2# show version

Dell EMC Networking OS10 Enterprise

OS Version: 10.5.0.5

Build Version: 10.5.0.5.661

Build Time: 2020-02-15T00:45:32+0000

System Type: MX9116N-ON

Architecture: x86_64

Up Time: 1 day 20:37:53

MX9116N-A2#

5. Run the command, show smartfabric cluster member, in the Master networking switch. Confirm that the STATUS

of the upgraded switch is ONLINE in the command output, after it has reloaded.

IOM# show smartfabric cluster member

Service-tag IP Address Status Role Type Chassis-Service-

Tag Chassis-Slot

MXWV122 xxxxxxxxxxx ONLINE MASTER MX9116n SKYMX02 A2

MXLE103 xxxxxxxxxxx ONLINE BACKUP MX9116n SKYMX10 B2

MXLE093 xxxxxxxxxxx ONLINE BACKUP MX9116n SKYMX09 B1

MXWV011 xxxxxxxxxxx ONLINE BACKUP MX9116n SKYMX01 A1

6. After step 5 is completed, proceed with upgrading the next Networking I/O Module.

Updating the management module firmware