Users Guide

Topics:
• Viewing hardware details
• Configuring IOM settings
Viewing hardware details
You can view information for the following IOM hardware:
● FRU
●
Device Management Info
● Installed Software
● Port Information
NOTE: If the physical port is added as part of the port channel, it is listed under the port channel group instead of the
physical port.
NOTE: The URL attribute is displayed as "N/A" on the Hardware > Device Management Info page for FC IOMs, owing to
device capability limitations.
For Port Information, when you enable auto-negotiation, peer devices exchange capabilities such as speed and settle on
mutually acceptable configuration. However, when the auto-negotiation is disabled, the peer devices may not exchange
capabilities. Hence, Dell EMC recommends that the configuration on both peer devices is identical.
The guidelines for auto-negotiation process are as follows:
● MX9116n, MX7116n, and MX5108n IOMs support only 25G speeds on server facing ports.
● By default, auto-negotiation is enabled on server facing 25G ports, as per the IEEE 802.3 Standard mandate.
● You can enable or disable auto-negotiation, but cannot configure speed on server facing ports.
● When auto-negotiation is enabled, Ethernet switches display speed capability of only 25G.
To view the hardware details:
Click I/O Modules > View Details > Hardware .
Configuring IOM settings
If you have the IOM device configuration privilege, you can configure the following settings for the MX9116n FSE and MX5108n
Ethernet Switch IOMs:
● Network
● Administrator password
● SNMP
● Time
You must have the network administrator privilege to configure the public management IP for the IOMs. The public IP facilitates
use of the IOM Command Line Interface (CLI) to configure and troubleshoot the IOMs.
Configuring IOM network settings
The network settings for IOMs include configuring the public management IP for the selected management port.
To configure the networking settings:
1. Click All Devices > I/O Modules > View Details > Settings > Network or Devices > I/O Modules > View Details >
Settings > Network.
2. In the IPv4 Settings section, select Enable IPv4.
3. Enter the IP Address, Subnet Mask, and Gateway for the management port.
The IP Address, Subnet Mask, and Gateway options are enabled only if the Enable DHCP check box is cleared.
NOTE:
For MX5108n and MX9116n IOMs, the default prefix length of the DHCP IP is 128 bits, though the DHCP server
is configured for 64 bits.
Ethernet IO Modules 73