Manualshelf

Users Guide

ManualsBrandsDell ManualsC SeriesPowerEdge MX7000
81828384858687888990
If you are required to configure new network other than the existing ones, click Add Network and enter the network details.
For more details see, Adding Network.
Adding network
You can use the Fabric and Configuration > Network pages to add networks. For more information, see Defining networks.
To add a new network from the Fabric page:
1. From the Devices drop down, select Fabric.
The Fabric page is displayed.
2. From the fabrics table, select the fabric and click View Details.
The Fabric Details page is displayed.
3. From the Uplinks section, click Add Uplink.
The Add Uplink window is displayed.
4. Click Add Network.
The Define Network window is displayed.
5. Enter Name, Description, VLAN ID and select the Network Type.
For the network types, see the Online Help.
Editing uplink
To edit an existing uplink:
1. From the Devices drop-down, select Fabric.
The Fabric page is displayed.
2. From the fabrics table, select the fabric and click View Details.
The Fabric Details page is displayed.
3. From the Uplinks table, select the uplink and click Edit.
The Edit uplink page is displayed.
4. Edit theName, Description, and Uplink Type fields as necessary, and then click Next.
5. Select the necessary Switch Ports and select any Tagged Networks or Untagged Networks.
To configure new network other than the existing ones, click Add Network and enter the network details. For more details
see, Adding Network.
NOTE: You cannot edit the ports or networks when uplinks are in FCoE, FC Gateway, or FC Direct Attach modes.
Viewing topology details
The fabric topology image displays only the operational status of the ports. If the operational status is "up", a check mark is
displayed. To view the graphical representation of the validation errors in an MCM scenario, go to the Group Topology page on
the OME–Modular web interface.
To view topology details:
● From the Devices drop-down, select Fabric.
● From the fabrics table, select the fabric and click View Details.
● From the Fabric Details page, click Topology.
The topology of the fabric is displayed.
Editing fabric details
To edit the fabric details:
1. From the Devices drop down, select Fabric.
The Fabric page is displayed.
2. From the fabrics table, select the fabric and click Edit.
The Edit Fabric page is displayed.
SmartFabric Services
85