Users Guide

The available options are:
● Manually
● Automatically
The default mode is manual.
5. Select the Update Frequency.
● Daily
● Weekly
The time can be in HH:MM format.
Editing catalogs
You can only modify the catalog name, network share address, and catalog filepath.
To edit catalogs:
1. On the Catalog Management page, select the catalog that you want to edit and click Edit.
The Edit Firmware Catalog window is displayed.
2. Make the required changes.
Deleting catalogs
You can only delete catalogs that are not associated with a baseline. If you attempt deleting a catalog that is associated with a
baseline, an error message is displayed.
To delete a catalog:
On the Catalog Management page, select the catalog that you want to delete and click Delete.
Updating firmware
Before updating the firmware on a chassis, compute, or storage sleds, ensure that all IOMs and network fabrics are healthy. You
can upgrade only six IOMs simultaneously.
NOTE:
The Update Firmware button may be disabled temporarily during inventory refresh when a Refresh Inventory job
or Default Inventory job is run.
To update firmware:
1. On the Compliance Report page, select the device or component for which you want to update the firmware.
The Update Firmware window is displayed.
2. Select the Update Now option to update the firmware immediately or Schedule Later to update the firmware on the
chosen date and time.
NOTE:
If the system displays the local clock on the Time Configuration page even after you configured the NTP
servers, reconfigure the NTP servers.
NOTE: During firmware update, when the active MM reboots and the standby MM is active, some messages on the
Execution Details page for the firmware update are not displayed. The messages are not displayed owing to
synchronization issues.
NOTE: During the OME–Modular firmware update, multiple users can upload the OME–Modular DUP using any
interface. However, a warning message may be displayed after the firmware update job is initiated.
NOTE: For non-default VLAN, the management IPv6 IP of MX9116n or MX5108n IOMs is unreachable if, the DHCP V6
configuration in ToR switch does not have the IPV6 default gateway.
Managing firmware 95