Setup Guide

Secured Component Verification on WinPE
This section provides information for the following:
Topics:
• Creating an ISO image to run SCV using WinPE
• Adding SCV to Custom ISO Image
• Adding RACADM to an ISO image
• Running SCV on WinPE
• How to check SCV logs using WinPE
Creating an ISO image to run SCV using WinPE
To create an ISO image to run SCV using WinPE:
1. Download the iDRAC tools from the Drivers & downloads page for your system at https://www.dell.com/support.
NOTE: SCV is supported on iDRAC Tools version 9.5.1 or later.
2. Ensure that Windows ADK and Windows PE add-on for ADK is installed in the system for WinPE 10.x. To download and install
the files, go to https://docs.microsoft.com/en-us/windows-hardware/get-started/adk-install.
3. Run the self-extractor file for iDRAC tools and click Unzip to extract the files to the default location.
NOTE:
To extract the files to a specified location, click on Browse and select the folder where the files need to be
extracted and click OK and then Unzip.
4. Launch command prompt and change directory to the location where the files were extracted. Run the batch file
(WinPE10.x_driverinst.bat) using command prompt to create a bootable ISO image.
Figure 1. Running the batch file through command prompt
5. Once the ISO image is created successfully, open the folder created with the name "WINPE10.x-%timestamp%", to find the
ISO image.
2
6 Secured Component Verification on WinPE