Users Guide

Table Of Contents
Configuring iDRAC
To configure iDRAC parameters applicable to the system, such as LAN, common IP settings, IPv4, IPv6, Virtual Media, and LAN
user configuration use the iDRAC Settings wizard.
NOTE: You can also use the System Setup utility during startup for configuring iDRAC. For more information about the
System Setup utility, see Using the System Setup Program and Boot Manager.
To configure and manage the iDRAC parameters:
1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
2. In the left pane of Home page, click Hardware Configuration.
3. In the right pane, click Configuration Wizards.
4. On the System Configuration Wizards page, click iDRAC Settings, and then click the following options to configure the
different iDRAC parameters.
For more information about configuring iDRAC settings, see the iDRAC User's Guide available at https://www.dell.com/
idracmanuals .
NOTE: Click System Summary to view the parameters and their values.
Network
OS to iDRAC Pass Through
Alerts
System Event Log
Virtual Media
Thermal
System Location
Front Panel Security
User Configuration
Smart Card
Lifecycle Controller
Remote Enablement
Reset iDRAC Configuration to defaults
5. Click Back after setting the parameters for each option to return to the main menu.
6. Click Finish to apply the changes.
Configuring system time and date
To set the time and date for the managed system:
1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
2. From the Lifecycle Controller Home page, select Hardware Configuration.
3. In the right pane, select Configuration Wizards.
4. Under System Configuration Wizards, click System Time and Date Configuration.
The default system time and system date displayed in Lifecycle Controller is the date and time reported by the system BIOS.
5. Modify the System Time and System Date (HH:MM:SS AM or PM), as required.
6. Click Finish to apply the changes.
Configuring RAID
If your system has one or more supported PERC RAID controllers with PERC 8 firmware or later, or software RAID controllers,
use the RAID Configuration wizard to configure a virtual disk as the boot device.
NOTE:
Create boot virtual disk only from disk drive populated across slots 03 of the system. For slot information, see the
server Owners Manual at https://www.dell.com/poweredgemanuals.
NOTE: If there are any internal storage controller cards on the system, all other external cards cannot be configured. The
external cards can be configured only if there are no internal cards.
Configure 39