Owners Manual
Table Of Contents
- Dell PowerEdge R430 Owner's Manual
- Dell PowerEdge R430 system overview
- Supported configurations for the PowerEdge R430 system
- Front panel
- Back panel features
- Diagnostic indicators
- Locating service tag of your system
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- Boot Settings
- Network Settings
- System Security
- System Information
- Memory Settings
- Processor Settings
- SATA Settings
- Integrated Devices
- Serial Communication
- System Profile Settings
- Miscellaneous Settings
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel (optional)
- System cover
- Inside the system
- Cooling shroud
- System memory
- Hard drives
- Removing a 2.5-inch hard drive blank
- Installing a 2.5-inch hard drive blank
- Removing a 3.5-inch hard drive blank
- Installing a 3.5-inch hard drive blank
- Removing a 3.5-inch cabled hard drive carrier
- Installing a 3.5-inch cabled hard drive carrier
- Removing a hot swappable hard drive carrier
- Installing a hot swappable hard drive carrier
- Removing a 3.5-inch hot swappable hard drive adapter from a 3.5-inch hot swappable hard drive carrier
- Installing a 3.5-inch hard drive adapter into a hot swap hard drive carrier
- Removing a 2.5-inch hard drive from a 3.5-inch hard drive adapter
- Installing a 2.5-inch hard drive into a 3.5-inch hard drive adapter
- Removing a hard drive or a solid state drive from a hard drive carrier
- Installing a hard drive or solid state drives into a hard drive carrier
- Optical drive (optional)
- Cooling fans
- Internal USB memory key (optional)
- Expansion cards and expansion card riser
- iDRAC port card (optional)
- SD vFlash card (optional)
- Internal dual SD module (optional)
- Integrated storage controller card
- Processors and heat sinks
- Power supply units
- System battery
- Hard-drive backplane
- Control panel
- Power interposer board
- System board
- Trusted Platform Module
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial input and output device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting power supply units
- Troubleshooting cooling problems
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting an internal USB key
- Troubleshooting a micro SD card
- Troubleshooting an optical drive
- Troubleshooting a drive or SSD
- Troubleshooting a storage controller
- Troubleshooting expansion cards
- Troubleshooting processors
- System messages
- Getting help
Table 21. Expansion card riser specifications
Expansion card riser PCIe slots on the riser Height Length Link
PCIE_G3_X16 riser
Slot 1 low-profile half-length x16
Slot 2 low-profile half-length x16
PCIE_G3_X8 riser
Slot 1 full-height half-length x8
Slot 2 low-profile half-length x8
Memory specifications
The PowerEdge R430 system supports DDR4 registered DIMMs (RDIMMs) and load-reduced DIMMs (LRDIMMs). Supported
memory bus frequencies are 1866 MT/s, 2133MT/s, or 2400 MT/s.
Table 22. Memory specifications
Memory module
sockets
Memory capacity Minimum RAM Maximum RAM
Twelve 288–pin
● 4 GB single rank (RDIMMs)
● 8 GB, 16 GB, or 32 GB dual
rank (RDIMMs)
● 4 GB with single processor
● 8 GB with dual processors
(minimum one memory
module per processor)
● Up to 256 GB with a single
processor
● Up to 384 GB with a dual
processor
Drive specifications
Hard drives
The PowerEdge R430 system supports SAS, SATA, Nearline SAS hard drives and Solid State Drives (SSDs).
Table 23. Supported hard drive and SSD options for the PowerEdge R430 system
Drive System Supports up to
Four hard drive systems
Up to four 3.5-inch cabled hard drives, or
Up to four 3.5-inch hot-swappable SAS, SATA, or Nearline
SAS hard drives, or
Up to four 2.5-inch hot-swappable SAS, SATA, SATA SSD, or
Nearline SAS hard drives.
NOTE: Four hard-drive systems support software RAID.
For more information about software RAID, see the Dell
PowerEdge RAID Controller (PERC) documentation at
dell.com/storagecontrollermanuals.
Eight hard-drive systems Up to eight 2.5-inch, hot-swappable SAS, SATA, SATA SSD,
or Nearline SAS hard drives
Ten hard-drive systems Up to ten 2.5-inch, hot-swappable SATA hard drive or SATA
SSD
Optical drive
The PowerEdge R430 system supports one optional SATA DVD-ROM drive or DVD+/-RW drive.
NOTE: The optical drive is supported on the four hard-drive systems and eight hard-drive systems.
34 Technical specifications