Manual

96 Installing System Components

Slide the new power supply into the chassis until the power supply is fully

seated and the release latch snaps into place. See Figure 3-8.

NOTE: If you unlatched the cable management arm in step 1 of the previous

procedure, relatch it. For information about the cable management arm, see

the system’s rack documentation.

Connect the power cable to the power supply and plug the cable into a

power outlet.

CAUTION: When connecting the power cable, secure the cable with the Velcro

strap.

NOTE: When installing, hot-swapping, or hot-adding a new power supply in a

system, allow several seconds for the system to recognize the power supply and

determine its status. The power-supply status indicator turns green to signify that

the power supply is functioning properly.

Removing the Power Supply Blank

If you are installing a power supply, remove the power supply blank by pulling

outward on the blank.

CAUTION: To ensure proper system cooling, the power supply blank must be

installed in power supply bay PS2 in a non-redundant configuration. Remove the

power supply blank only if you are installing a second power supply.

Installing the Power Supply Blank

To install the power supply blank, align the blank with the power supply bay

and insert the blank into the chassis until it clicks into place.

Cooling Shroud

The cooling shroud covers the memory modules and provides air flow to the

system.

Removing the Cooling Shroud

CAUTION: Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your

product documentation, or as directed by the online or telephone service and

book.book Page 96 Thursday, February 18, 2010 2:06 PM