Setup Guide

Dell™ Rack Installation Guide 15
Installing the VersaRails Slide Assemblies
1 At the front of the rack cabinet, place a VersaRails slide assembly so that
its mounting-bracket flange fits between the marks or tape (or numbered
location) on the rack (see Figure 1-6).
The holes on the front of the mounting bracket should align with the holes
between the marks on the front vertical rail.
2 Install a 10-32 x 0.5-inch flange-head Phillips screws in the mounting
flange’s top hole and the bottom hole (see Figure 1-6).
3 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting holes align with their respective holes on the back vertical
rail.
4 Install 10-32 x 0.5-inch flange-head Phillips screws in the second and third
holes (middle holes) of the back mounting flange to secure the slide
assembly to the back vertical rail.
NOTE: The top and bottom flange holes will be used later for installing the
cable-management arm retainer.
5 Repeat steps 1 through 4 for the slide assembly on the other side of the
rack.
NOTE: Ensure that the rails are mounted at the same vertical position on both
sides of the rack.