Instruction Manual

Cable Routing Procedures for Dell™ PowerEdge™ R515 Systems
Page 7
Figure 7: Cable Routing Without a CMA
2.2 Removing the CMA Brackets for Shallow Racks
If you are installing the system into a shallow rack (less than 1 meter deep) and you will not be
installing a CMA, the outer CMA brackets may be removed if necessary in order to allow the rails to fit
properly into the rack. Remove the brackets by using a #2 Phillips screwdriver to remove the screws
used to attach them to the rails as shown in Figure 8.
Figure 8: Removing the CMA Brackets for Shallow Racks