Instruction Manual

60 Installing and Configuring Hardware

Replacing the Battery and Battery Cable Onto the

DIMM of a PERC H800 Adapter

With the old TBBU or TNVC removed from the controller, disconnect the

battery cable from both ends and press out on the battery clips inserted

through the DIMM rotating the battery out of the DIMM. See

Figure 4-15.

Figure 4-15. Removing the Battery and Battery Cable From a PERC H800 Adapter

Unpack the new TBBU or TNVC and follow all antistatic procedures.

Insert one end of the battery cable into the connector on the

DIMM

and

the other end into the connector on the new battery.

NOTE: Do not exert excessive pressure connecting the cable. It is a keyed

connector and it fits only one way.

Place the top edge of the battery over the top edge of the

DIMM

so that

the arms on the side of the battery fit into their sockets on the

DIMM

See Figure 4-16.

1 DIMM 2 battery

PERC7.2_UG.book Page 60 Thursday, March 3, 2011 2:14 PM