Owners Manual

5. Slide the power-supply divider out of the chassis.

6. Align the tabs of the new power-supply divider with the slots of the power supply unit cage .

7. Rotate the power-supply divider counter-clockwise and slide it in until the power-supply divider is seated in the

slots of the power supply unit cage .

8. Secure the power supply divider to the chassis using the screw.

9. Install the redundant power supply module(s) or power supply blank as applicable.

10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Figure 54. Removing and Installing the Power-Supply Divider

1. power supply divider 2. tabs (4)

3. screw

Non-Redundant AC Power Supply

Your system supports a non-redundant 550 W AC power supply.

NOTE: Non-redundant power supply is supported in systems with cabled hard drives and systems with an x8

backplane.

NOTE: When selecting or upgrading your system configuration, verify the system power consumption with the Dell

Energy Smart Solution Advisor at dell.com/ESSA to ensure optimum power utilization.