CLI Guide

• To create, delete, and secure the virtual disks. To start or stop

the consistency check on the specified virtual disk, run the

following command:

racadm storage createvd:<Controller FQDD>

-rl {r0|r1|r5|r6|r10|r50|r60}[-wp {wt|wb|

wbf}] [-rp {nra|ra|ara}] [-ss {1k|2k|4k|

8k|16k|32k|64k|128k|256k|512k|1M|2M|4M|8M|

16M}]-pdkey:<comma separated PD FQDD> [-

dcp {enabled|disabled|default}] [-name

<VD name>] [-size <VD size>{b|k|m|g|t}] [-

T10PIEnable]

NOTE: T10PI is not supported on PERC 9 and PERC

10.

racadm storage init:<VD FQDD> -speed

{fast|full}

racadm storage deletevd:<VD FQDD>

racadm storage encryptvd:<VD FQDD>

racadm storage

createsecuritykey:<Controller FQDD> -key

NOTE:

createsecuritykey command is not supported

on H3xx PERC controllers.

racadm storage

modifysecuritykey:<Controller FQDD> -key

<Key id>-xxx <old passphrase> -xxx <new

passphrase>

racadm storage

deletesecuritykey:<Controller FQDD>

racadm storage ccheck:<vdisk fqdd>

racadm storage cancelcheck:<vdisk fqdd>

• To convert the physical disk drives and assign or delete a

hotspare. To scan physical disks connected to a controller and

detect problem, run the following command:

racadm storage converttononraid:<PD FQDD>

RACADM Subcommand Details

123