CLI Guide

• The minimum Lifecycle Controller version 1.3 is required.
• The minimum Lifecycle Controller version 2 1.3 is required.
Synopsis
• racadm systemconfig backup -f <filename> <target> [-n passphrase] [-l
<location> -u <user name> -p <password>] [--vFlash]
• racadm systemconfig restore -f <filename> <target> [-n passphrase ] [--
nopreserve] [-l <location> -u <user name> -p <password>] [--vFlash]
• To create an AutoBackup Schedule.
racadm systemconfig backup [-f <filename>] <target> [-n <passphrase>][-l
<location> -u <user name> -p <password>] [--vFlash] -time <time> [-dom
<DayOfMonth>] [-wom <WeekOfMonth>] [-dow <DayofWeek>] -rp <repeat> -mb
<MaxBackup>
• To view an AutoBackup Schedule.
racadm systemconfig getbackupscheduler
• To delete an AutoBackup Schedule.
racadm systemconfig clearbackupscheduler
NOTE: After the parameters are cleared, the AutoBackupScheduler is disabled. To schedule the
backup again, enable the AutoBackupScheduler.
Input
• -n — Specifies a pass phrase used to encrypt or decrypt the configuration data. The pass phrase must have 8
to 32 characters, and one upper and lower case character.
NOTE: This pass phrase is optional.
• -l — Specifies the network share location, can be either CIFS or NFS.
• -f — Specifies the image location and the file name.
NOTE: If the file is in a subfolder within the share location, then specify the network share
location in the –l option and specify the subfolder location and the filename in the –f option.
•
-u — Specifies the user name for the remote share access.
• -p — Specifies the password for the remote share access.
• --vFlash — Selects vFlash SD as target location for back up.
• --nopreserve — Deletes all the virtual disks and configurations.
• -time: Specifies the time to schedule an autobackup in HH:MM format. This parameter must be specified.
• -dom: Specifies the day of month to schedule an autobackup. Valid values are 1–28, L(Last day) or '*' (default
— any day).
• -wom: Specifies the week of month to schedule an autobackup. Valid values are 1–4, L(Last week) or '*'
(default — any week).
• -dow: Specifies the day of week to schedule an autobackup. Valid values are sun, mon, tue, wed, thu, fri, sat, or
'*' (default — any day).
NOTE: The -dom, -wom, or -dow option must be included in the command for the autoupdate
schedule. The * value for the options must be included within ' ' (single quotation mark).
• If the -dom option is specified, then the -wom and -dom options are not required.
• If the-wom option is specified, then the-dow is required and -dom is not required.
• If the-dom option is non-'*', then the schedule repeats by month.
•
If the-wom option is non-'*', then the schedule repeats by month.
• If the-dom and -wom options are '*' and the -dow option is non-'*', then the schedule repeats by
week.
• If all the three -dom, -wom and -dow options are '*', then the schedule repeats by day.
• -rp: Specifies the repeat parameter. This parameter must be specified.
• If the-dom option is specified, then the valid values for -rp are 1–12.
140
RACADM Subcommand Details