CLI Guide

• View the current test trap settings.
racadm get iDRAC.SNMP.Alert.<index>
where <index> is a number from 1 to 8
• Send a test trap to the destination configured for index 1:
racadm testtrap -i 1
testalert
Table 102. Details of testalert
Description Tests FQDN supported SNMP trap notifications.
To run this subcommand, you must have the Test Alert User Access.
Synopsis
racadm testalert -i <index>
Input -i — Specifies the index of the trap test. index must be an integer from 1 to 8 on iDRAC.
Output
Success: Test trap sent successfully
Failure: Unable to send test trap
Example
• Test a trap with index as 1.
racadm testalert -i 1
Test trap sent successfully.
• Test a trap that has not been configured yet.
racadm testalert -i 2
ERROR: Trap at specified index is not currently enabled.
traceroute
Table 103. Details of traceroute attribute
Description Traces network path of the routers as the packets traverse from the system to a destination IPv4 address.
To run this subcommand, you must have the Administrator privilege.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm traceroute <IPv4 address>
Input IPv4 — Specifies IPv4 address.
Output
traceroute to 192.168.0.1 (192.168.0.1), 30 hops max, 40 byte packets
1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms
146 RACADM Subcommand Details