CLI Guide

traceroute6
Table 104. Details of traceroute6 attribute
Description Traces the network path of routers as the packets traverse from the system to a destination IPv6 address.
To run this subcommand, you must have the Administrator privilege.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm traceroute6 <IPv6address>
Input <IPv6address> – Specifies IPv6 address.
Output
traceroute to fd01::1 (fd01::1) from fd01::3,
30 hops max, 16 byte packets
1 fd01::1 (fd01::1) 14.324 ms 0.26 ms 0.244 ms
update
Table 105. Details of update
Description
Allows you to update the firmware of devices on the server. The supported firmware image file types are:
• .exe — Windows-based Dell Update Package (DUP)
•
.d7
•
.pm
The supported catalog files are:
• .xml
• xml.gzip
NOTE: Updating the platforms from the repository is not supported for IPv6.
NOTE: Depending on the network traffic, the HTTP packet transfer may fail if you perform update
operation from a remote RACADM through a local share. In such cases, retry the operation. If the
issue persists, use remote RACADM with the CIFS or NFS share.
NOTE: This command supports both IPV4 and IPV6 formats. IPV6 is applicable only for CIFS, HTTP
and HTTPS remote shares.
RACADM Subcommand Details 147