CLI Guide

• Example 3:
racadm> getl<press tab>
racadm> getled <press enter> or <racadm getled>
LEDState: Not-Blinking
• Example 4:
racadm>> get bios.uefiBootSettings
BIOS.UefiBootSettings
BIOS.UefiBootSettings.UefiBootSeq
BIOS.UefiBootSettings.UefiPxeIpVersion
NOTE: In the RACADM autocomplete mode, some of the RACADM commands specific to certain server platforms may
not be available. In such scenarios, execute the RACADM command in the normal execution mode.
NOTE: In the RACADM autocomplete mode, type the commands directly without giving racadm as prefix.
NOTE: The RACADM get or set attributes with value length up to 512 characters are supported from autocomplete
mode. If the value length is 512 characters or more, execute the RACADM command in the normal execution mode.
Lifecycle Controller Log
Lifecycle Controller logs provide the history of changes related to components installed on a managed system. You can also add work
notes to each log entry.
The following events and activities are logged:
• System events
• Storage devices
• Network devices
• Configuration
• Audit
• Updates
You can view and filter logs based on the category and severity level. You can also export and add a work note to a log event.
If you initiate configuration jobs using RACADM CLI or iDRAC web interface, the Lifecycle log captures the information about the user,
interface used, and the IP address of the system from which you initiate the job.
Proxy parameters
Some commands do not support setting the proxy parameters if the share location (-l) is HTTP/HTTPS. To perform the operation with
HTTP or HTTPS through a proxy, the proxy parameters must be first configured using the lifecyclecontroller.lcattributes. Once these
proxy parameters are configured, they become the part of default configuration; the proxy attributes should be cleared to end use of the
HTTP/HTTPS proxy.
The valid lifecyclecontroller.lcattributes HTTP/HTTPS proxy parameters are:
• UserProxyUserName
• UserProxyPassword
• UserProxyServer
• UserProxyPort
• UserProxyType
To view the list of proxy attributes, use racadm get lifecycleController.lcAttributes.
NOTE:
Squid proxy configuration is not supported to access HTTP/HTTPS shares.
Introduction 37