CLI Guide

collisions:0 txqueuelen:1000

RX bytes:272532097 (259.9 MiB) TX bytes:0 (0.0 B)

inlettemphistory

Table 62. Details of inlettemphistory

Description

Displays the average and the peak temperatures during the last hour, day, week, month, or year. Also Exports the

inlet temperature history data file. The file can be exported to a remote file share, local file system, or the

management station.

NOTE: For FM120x4 systems, this subcommand provides the historical data for system board

temperature.

Synopsis

• racadm inlettemphistory export –f <filename> –t <type> [–u <username of the

network share>] [–p <password for the remote share>] [-i <network share

location>]

• racadm inlettemphistory get

Input

• -f — Exports inlet temperature history filename. The maximum length of this parameter is 64 characters.

NOTE: If a file with the specified filename exists, then the older file is replaced with the new

history file.

• -u — User name of the remote share to export the file. Specify user name in a domain as domain or username.

• -p — Password for the remote share to where the file must be exported.

• -l — Network share location to where the inlet temperature history must be exported. The maximum length of

this parameter is 256 characters.

NOTE: Export to an IPv6 NFS share is not supported.

•

-t — Specifies the exported file type. Valid values are xml and csv. These values are case-insensitive.

NOTE: From firmware RACADM, only export to a remote share is supported. The behavior of remote

share is not defined when the path specified (-l) contains special characters.

Example

• Export the log to a remote CIFS share.

racadm inlettemphistory export -f Mylog.xml -u admin -p xxx -l //1.2.3.4/

share -t xml

• Export the log to local file system using Local RACADM.

racadm inlettemphistory export -f Mylog.xml -t xml

• Export the log to management station using Remote RACADM.

racadm -r 1.2.3.4 -u user -p xxx inlettemphistory export -f Mylog.csv -t csv

• View the inlet temperature history.

racadm inlettemphistory get

Duration Above Warning Threshold as Percentage = 0.0%

Duration Above Critical Threshold as Percentage = 0.0%

Average Temperatures

Last Hour = 23C ( 73.4F )

Last Day = 24C ( 75.2F )

Last Week = 24C ( 77.0F )

Last Month = 25C ( 77.0F )

Last Year = 23C ( 73.4F )

RACADM Subcommand Details