CLI Guide

Total Unicast Bytes Transmitted: 0
• To get the network statistics, type the following command:
$ racadm nicstatistics
NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:10
NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:11
NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:12
NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:13
NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:14
ping
Table 69. Details of ping attribute
Description Verifies if the destination IP address is reachable from iDRACCMC with the current routing-table contents. A
destination IP address is required. Based on the current routing-table contents, an ICMP echo packet is sent to the
destination IP address.
To run this subcommand, you must have the Administrator privilege.
To run this subcommand, you must have the Debug privilege.
Synopsis
racadm ping <ipaddress>
Input <ipaddress> — The IP address of the remote endpoint to ping.
Output
PING 192.168.0 (192.168.0): 56 data bytes64 bytes from 192.168.0: seq=0
ttl=64 time=4.121 ms
192.168.0 ping statistics
1 packets transmitted, 1 packets received, 0 percent packet lossround-trip
min/avg/max = 4.121/4.121/4.121 ms
ping6
Table 70. Details of ping6 attribute
Description
Verifies if the destination IPv6 address is reachable from iDRAC or with the current routing-table contents. A
destination IPv6 address is required. Based on the current routing-table contents, an ICMP echo packet is sent to
the destination IPv6 address.
Verifies if the destination IPv6 address is reachable from CMC or with the current routing-table contents. A
destination IPv6 address is required. Based on the current routing-table contents, an ICMP echo packet is sent to
the destination IPv6 address.
To run this subcommand, you must have the Administrator privilege.
To run this subcommand, you must have Debug privilege.
Synopsis
racadm ping6 <ipv6address>
Input <ipv6address> — the IPv6 address of the remote endpoint to ping.
RACADM Subcommand Details 95