CLI Guide

Current IP Address = 192.168.0.1
Current IP Gateway = 192.168.0.1
Current IP Netmask = 192.168.0.1
DHCP Enabled = 0
Current DNS Server 1 = 0.0.0.0
Current DNS Server 2 = 0.0.0.0
DNS Servers from DHCP = Disabled
IPv6 settings:
Enabled = 0
Current IP Address 1 = ::
Current IP Gateway = ::
Autoconfig = 1
Link Local IP Address = ::
Current IP Address 2 = ::
Current IP Address 3 = ::
Current IP Address 4 = ::
Current IP Address 5 = ::
Current IP Address 6 = ::
Current IP Address 7 = ::
Current IP Address 8 = ::
Current IP Address 9 = ::
Current IP Address 10 = ::
Current IP Address 11 = ::
Current IP Address 12 = ::
Current IP Address 13 = ::
Current IP Address 14 = ::
Current IP Address 15 = ::
DNS Servers from DHCPv6 = Disabled
Current DNS Server 1 = ::
Current DNS Server 2 = ::
System Information:
System Model = PowerEdge R720
System Revision = I
System BIOS Version = 2.0.18
Service Tag =
Express Svc Code =
Host Name = localhost.localdomain
OS Name =
OS Version =
Power Status = ON
Fresh Air Capable = No
Watchdog Information:
Recovery Action = None
Present countdown value = 478 seconds
Initial countdown value = 480 seconds
Embedded NIC MAC Addresses:
NIC.Integrated.1-3-1 Ethernet = 78:2B:CB:4B:C2:ED
NIC.Integrated.1-1-1 Ethernet = 78:2B:CB:4B:C2:EB
===============================================================================
Coredump Information
===============================================================================
There is no coredump currently available.
===============================================================================
Network Interface Statistics
===============================================================================
Kernel IPv6 routing table
Destination Next Hop Flags
Metric Ref Use Iface
::1/128 :: U
0 1 1 lo
::1/128 :: U
256 0 0 lo
fe80::1a03:73ff:fef7:b7ca/128 :: U
0 0 1 lo
fe80::/64 :: U
256 0 0 eth1
RACADM Subcommand Details
99