Users Guide

For information about the options, see the iDRAC Online Help.
The IPMI over LAN settings are configured.
Configuring IPMI over LAN using iDRAC settings utility
To configure IPMI over LAN:
1. In the iDRAC Settings Utility, go to Network.
The iDRAC Settings Network page is displayed.
2. For IPMI Settings, specify the values.
For information about the options, see the iDRAC Settings Utility Online Help.
3. Click Back, click Finish, and then click Yes.
The IPMI over LAN settings are configured.
Configuring IPMI over LAN using RACADM
To configure IPMI over LAN using set or config command:
1. Enable IPMI over LAN:
• Using config command: racadm config -g cfgIpmiLan -o cfgIpmiLanEnable 1
• Using set command: racadm set iDRAC.IPMILan.Enable 1
NOTE: This setting determines the IPMI commands that are executed using IPMI over LAN
interface. For more information, see the IPMI 2.0 specifications at intel.com.
2. Update the IPMI channel privileges:
• Using config command: racadm config -g cfgIpmiLan -o cfgIpmiLanPrivilegeLimit
<level>
• Using set command: racadm set iDRAC.IPMILan.PrivLimit <level>
where <level> is one of the following: 2 (User), 3 (Operator) or 4 (Administrator)
3. Set the IPMI LAN channel encryption key (if required):
• Using config command: racadm config -g cfgIpmiLan -o cfgIpmiEncryptionKey
<key>
• Using set command: racadm set iDRAC.IPMILan.EncryptionKey <key>
where <key> is a 20-character encryption key in a valid hexadecimal format.
NOTE: The iDRAC IPMI supports the RMCP+ protocol. For more information, see the IPMI 2.0
specifications at intel.com.
Enabling or disabling remote RACADM
You can enable or disable remote RACADM using the iDRAC Web interface or RACADM. You can run up
to five remote RACADM sessions in parallel.
Enabling or disabling remote RACADM using web interface
To enable or disable remote RACADM:
1. In iDRAC Web interface, go to Overview → iDRAC Settings → Network → Services.
136