Users Guide

7. Click Next. The Active Directory Configuration and Management Step 3 of 4 page is displayed.

8. Select Standard Schema and click Next.

The Active Directory Configuration and Management Step 4a of 4 page is displayed.

9. Enter the location of Active Directory global catalog server(s) and specify privilege groups used to

authorize users.

10. Click a Role Group to configure the control authorization policy for users under the standard

schema mode.

The Active Directory Configuration and Management Step 4b of 4 page is displayed.

11. Specify the privileges and click Apply.

The settings are applied and the Active Directory Configuration and Management Step 4a of 4 page

is displayed.

12. Click Finish. The Active Directory settings for standard schema are configured.

Configuring Active Directory with Standard schema using RACADM

To configure iDRAC Active Directory with Standard Schema using the RACADM:

1. At the racadm command prompt, run the following commands:

• Using config command:

racadm config -g cfgActiveDirectory -o cfgADEnable 1

racadm config -g cfgActiveDirectory -o cfgADType 2

racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupName

racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupDomain

racadm config -g cfgStandardSchema -i <index> -o

cfgSSADRoleGroupPrivilege <Bit Mask Value for specific RoleGroup

permissions>

racadm config -g cfgActiveDirectory -o cfgADDomainController1 <fully