Users Guide

-u:<admin-username> -p:<admin-passwd> -r:http://<remote-hostname OR IP>/
wsman -a:Basic -encoding:utf-8 -skipCACheck –skipCNCheck
• Linux operating system
On all iSM supported Linux operating system, iSM provides an executable command. You can run this
command by logging into the operating system by using SSH or equivalent.
– To enable this feature:
Enable-iDRACSNMPTrap.sh 1
Enable-iDRACSNMPTrap.sh enable
– To disable this feature:
Enable-iDRACSNMPTrap.sh 0
Enable-iDRACSNMPTrap.sh disable
NOTE: The --force option configures the Net-SNMP to forward the traps. However, you must
configure the trap destination.
• VMware ESXi operating system
On all iSM supported ESXi operating systems, the iSM v2.3 supports a Common Management
Programming Interface (CMPI) method provider to enable this feature remotely by using the WinRM
remote commands.
winrm i EnableInBandSNMPTraps http://schemas.dell.com/wbem/wscim/1/cim-
schema/2/root/cimv2/dcim/DCIM_iSMService?
__cimnamespace=root/cimv2/dcim+InstanceID=iSMExportedFunctions -u:<user-
name> -p:<passwd> -r:https://<remote-host-name
ip-address>:443/wsman -a:basic -encoding:utf-8 -skipCNCheck -skipCACheck -
skipRevocationcheck @{state="[0/1]"}
NOTE: You must review and configure the VMware ESXi system-wide SNMP settings for traps.
NOTE: For more details, refer to the In-BandSNMPAlerts technical white paper available at http://
en.community.dell.com/techcenter/extras/m/white_papers.
iDRAC access via Host OS (Experimental Feature)
By using this feature, you can configure and monitor the hardware parameters through iDRAC Web
interface, WS-MAN, and RedFish interfaces using the host IP address without configuring the iDRAC IP
address. You can use the default iDRAC credentials if the iDRAC server is not configured or continue to
use the same iDRAC credentials if the iDRAC server was configured earlier.
iDRAC access via Windows Operating Systems
You can perform this task by using the following methods:
• Install the iDRAC access feature by using the webpack.
• Configure using iSM PowerShell script
Installation by using MSI
You can install this feature by using the webpack This feature is disabled on a typical iSM installation.
While enabling this feature, you are prompted to enter a unique listen port number, which ranges from
1024 to 65535. The iSM redirects the connection to the iDRAC. iSM then creates an in-bound firewall
315