Users Guide

Configuring iDRAC Quick Sync
Using iDRAC web interface or RACADM, you can configure iDRAC Quick Sync feature to allow access to
the mobile device:
• Access — You can specify any of the following options to configure the access state of iDRAC Quick
Sync feature:
– Read-Write — Default status.
– Read-write access – Allows you to configure the basic iDRAC settings.
– Read-only access – Allows you to view inventory and monitoring information.
– Disabled access – Does not allow you to view information and configure settings.
• Time-out — You can enable or disable iDRAC Quick Sync inactivity timer:
– If enabled, you can specify a time after which the Quick Sync mode is turned off. To turn on, press
the activation button again.
– If disabled, the timer does not allow you to enter a time-out period.
• Time-out Limit — Allows you specify the time after which the Quick Sync mode is disabled. The
default value is 30 seconds.
You must have Server Control privilege to configure the settings. A server reboot is not required for the
settings to take effect.
An entry is logged to the Lifecycle Controller log when the configuration is modified.
Configuring iDRAC Quick Sync settings using web interface
To configure iDRAC Quick Sync:
1. In the iDRAC web interface, go to Overview → Hardware → Front Panel.
2. In the iDRAC Quick Sync section, from the Access drop-down menu, select one of the following to
provide access to the Android mobile device:
• Read-write
• Read-only
• Disabled
3. Enable the Timer.
4. Specify the Timeout value.
For more information about the fields, see the iDRAC Online Help.
5. Click Apply to apply the settings.
Configuring iDRAC Quick Sync settings using RACADM
To configure the iDRAC Quick Sync feature, use the racadm objects in the System.QuickSync group. For
more information, see the iDRAC RACADM Command Line Reference Guide available at dell.com/
esmmanuals.
325