Users Guide

NOTE: Failover is not supported on shared LOM for the following Emulex rNDCs and bNDCs:

• Emulex OCM14104-UX-D rNDC 10 Gbx

• Emulex OCM14104-U1-D rNDC 10 Gb

• Emulex OCM14104-N1-D rNDC 10 Gb

• Emulex OCM14104B-N1-D rNDC 10 Gb

• Emulex OCM14102-U2-D bNDC 10 Gb

• Emulex OCM14102-U4-D bNDC 10 Gb

• Emulex OCM14102-N6-D bNDC 10 Gb

NOTE: On Dell PowerEdge FM120x4 and FX2 servers, Failover Network is not supported for the

chassis sled configurations. For more information about the chassis sled configurations, see the

Chassis Management Controller (CMC) User’s Guide available at dell.com/idracmanuals.

NOTE: On PowerEdge FM120x4 servers, while configuring the Enhanced Network Adapter

Isolation, ensure that LOM2 is disabled on the host system and is not selected for iDRAC NIC.

For more information about the chassis sled configurations, see the Chassis Management

Controller (CMC) User’s Guide available at dell.com/idracmanuals.

4. Under Auto Negotiation, select On if iDRAC must automatically set the duplex mode and network

speed. This option is available only for dedicated mode. If enabled, iDRAC sets the network speed to

10, 100, or 1000 Mbps based on the network speed.

5. Under Network Speed, select either 10 Mbps or 100 Mbps.

NOTE: You cannot manually set the Network Speed to 1000 Mbps. This option is available only

if Auto Negotiation option is enabled.

6. Under Duplex Mode, select Half Duplex or Full Duplex option.

NOTE: If you enable Auto Negotiation, this option is grayed-out.

Common settings

If network infrastructure has DNS server, register iDRAC on the DNS. These are the initial settings

requirements for advanced features such as Directory services—–Active Directory or LDAP, Single Sign

On, and smart card.

To register iDRAC:

1. Enable Register DRAC on DNS.

2. Enter the DNS DRAC Name.

3. Select Auto Config Domain Name to automatically acquire domain name from DHCP. Else, provide

the

DNS Domain Name.

IPv4 settings

To configure the IPv4 settings:

1. Select Enabled option under Enable IPv4 .

2. Select Enabled option under Enable DHCP , so that DHCP can automatically assign the IP address,

gateway, and subnet mask to iDRAC. Else, select Disabled and enter the values for:

• Static IP Address

• Static Gateway

• Static Subnet Mask