Users Guide

Object Description Usage Example
If a system does not support a
particular air exhaust temperature
limit, then when you run the
following command:
racadm set
system.thermalsettings.AirE
xhaustTemp 0
The following error message is
displayed:
ERROR: RAC947: Invalid
object value specified.
Make sure to specify the value
depending on the type of object.
For more information, see RACADM
help.
To set the limit to the default value:
racadm set
system.thermalsettings.AirE
xhaustTemp 255
FanSpeedHig
hOffsetVal
• Getting this variable reads
the fan speed offset value
in %PWM for High Fan
Speed Offset setting.
• This value depends on
the system.
• Use FanSpeedOffset
object to set this value
using index value 1.
Values from 0-100
racadm get
system.thermalsettings
FanSpeedHighOffsetVal
This returns a value such as “66”.
This means that when you use the
following command, it applies a fan
speed offset of High (66% PWM)
over the baseline fan speed
racadm set
system.thermalsettings
FanSpeedOffset 1
FanSpeedLow
OffsetVal
• Getting this variable reads
the fan speed offset value
in %PWM for Low Fan
Speed Offset setting.
• This value depends on
the system.
• Use FanSpeedOffset
object to set this value
using index value 0.
Values from 0-100
racadm get
system.thermalsettings
FanSpeedLowOffsetVal
This returns a value such as “23”.
This means that when you use the
following command, it applies a fan
speed offset of Low (23% PWM)
over baseline fan speed
racadm set
system.thermalsettings
FanSpeedOffset 0
FanSpeedMax
OffsetVal
• Getting this variable reads
the fan speed offset value
in %PWM for Max Fan
Speed Offset setting.
• This value depends on
the system.
Values from 0-100
racadm get
system.thermalsettings
FanSpeedMaxOffsetVal
62