User Manual

Front Panel Controls

Back Panel Overview



Choosing a Location

Choose a location that meets the following criteria (see "Technical Specifications"):



Power Switch

Media Door

Front Panel LEDs

Front Panel LCD Screen

Control Keys



68-pin SCSI Connectors

Fan Vent

Power Connector

Bar Code Reader (optional)

NOTE: The arrows indicate the screws on the back of the unit that need to be removed if you want to remove the cover. Three additional

screws on each side of the unit must also be removed in order to lift the top cover.



Standalone

Requirements

Select a location that is flat, sturdy, level, and close to a host server. Do not place the autoloader on the floor or other

carpeted surfaces.

NOTICE:Donotplacetheautoloaderonitssideorupsidedownorstackitemsthatweighmorethan15KG

(33lb)ontopoftheautoloader.

Rack Requirements

Standard 19-inch rack with 2U of clearance.

Room Temperature

10–40ºC (50–104ºF)

Power Source

AC power voltage: 100–127 VAC; 200–240 VAC

Line frequency: 50–60 Hz

NOTE: Locate the AC outlet near the autoloader. The AC power cable is the product's main AC disconnect device

and must be easily accessible at all times.

Weight

12 kg (26 lb)

Air Quality

Minimize sources of particulate contamination. Avoid areas near frequently used doors and walkways, stacks of supplies

that collect dust, printers, and smoke-filled rooms.

NOTICE: Excessive dust and debris can damage tapes and tape drives.

Humidity

20–80% RH

Clearance

Back:Minimumof15.4cm(6in)

Front:Minimumof30.8cm(12in)

Sides:Minimumof5.08cm(2in)