Manual

Front Panel Error Types
EA
LCD Busy Error
Possible LCD controller problem, software error, or communication error.
l Power cycle the autoloader.
l Run the Random Moves test.
l If all previous steps fail, see Contacting Dell.
EB
LCD Goto Error
EC
Login/Password Error
Incorrect login from front panel.
l Use correct login/password.
ED
Socket Error During SNTP
Barcode Error Types
F0
Bar Code Init Error
l Remove magazines and inspect cartridges. Verify that valid barcode labels are being used on all
cartridges, and re-insert the magazines.
l If barcode labels are not being used, disable the barcode reader through the Operator Control Panel
or Remote Management Unit.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
F1
Bar Code Hardware Error
F2
Bar Code Baud Rate Error
F3
Bar Code Handshake Error
F4
Bad/Noisy Response From Bar
Code Reader
F5
Checksum Failed
Incomplete barcode label or barcode checksum failed.
l Repeat test with new cartridge or label.
l If problems recur with the original cartridge or label, replace.
l If all previous steps fail, see Contacting Dell.
F6
Barcode No Read
Barcode label not present.
l Apply valid barcode label to cartridge, or disable the barcode reader through the Operator Control
Panel or Remote Management Unit.
F7
Barcode Mismatch Error
l Power cycle the autoloader.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
F8
Barcode Duplicate Label Error
Duplicate barcode.
Diagnostic Error Types
F9
Diagnostic Test Failure
l Power cycle the autoloader.
l Re-run the failing diagnostic test.
l If all previous steps fail, see Contacting Dell.
FA
Diagnostic Error, Drive
Reporting Write Protect
l Verify that valid, not data protected media is present for test.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
FB
Diagnostic Error, Cleaning Tape
Inserted
FC
Diagnostic Load Tape Prompt
This is a prompt to manually load a cartridge as required for test.
FD
Diagnostic Unknown Tape
Format
l Verify that valid, not data protected media is present for test.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell.
FE
Diagnostic Invalid Configuration
This is an indication that a minimum of two pieces of media are required for test.
l Insure at least two cartridges are present in the autoloader and re-run the failed test.