Users Guide

(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\Hendrix\Ts\standalone\5920Pam0.fm

DELL CONFIDENTIAL - PRELIMINARY 2/15/99

™

P/N 5920P December 1998

&

www.dell.com

,QVWDOOLQJWKH'HOO3RZHU9DXOW

[ 66WDE LO L]HUV IRU6W DQG DO RQH

&RQILJXUDWLRQ

Perform the following steps to attach the stabilizers to the chassis, which converts a

Dell PowerVault 20

S storage system to a free-standing, vertical configuration:

1. Carefully turn the chassis upside down.

2. Locate the two pairs of screw holes on the bottom panel.

3. Align one of the stabilizers with one pair of screw holes, and then align the other

stabilizer with the other pair of screw holes, as shown in Figure 1.

)LJXUH$WWDFKLQJWKH6WDELOL]HUV

stabilizers (2)

bottom of chassis

PAGE 1
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\Hendrix\Ts\standalone\5920Pam0.fm ,QVWDOOLQJ WKH 'HOO 3RZHU9DXOW [6 6WDELOL]HUV IRU 6WDQG DORQH &RQILJXUDWLRQ Perform the following steps to attach the stabilizers to the chassis, which converts a Dell PowerVault 20xS storage system to a free-standing, vertical configuration: 1. Carefully turn the chassis upside down. 2. Locate the two pairs of screw holes on the bottom panel. 3.
PAGE 2
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\Hendrix\Ts\standalone\5920Pam0.fm 4. Use the four screws that came with your kit to secure the stabilizers to the bottom of the chassis. 5. Carefully turn the chassis over, so the stabilizers are at the bottom. ____________________ Information in this document is subject to change without notice. © 1998 Dell Computer Corporation. All rights reserved. Printed in the U.S.A.