Users Guide

support.dell.com Mensajes de error A-11
El puerto no está recibiendo señal (indicador LED negro fijo):
There is no G_Port board or no GBIC module for this port.
Please check the switch front panel.
(No hay una tarjeta G_Port o un módulo GBIC para este
puerto.
Por favor revise el panel anterior de interruptores.)
El puerto está recibiendo señal, pero todavía no está en línea (indicador LED ámbar
fijo):
Cable is partially inserted in the port, or the device at
the other end of the cable is not functioning properly.
Please check the switch front panel or check the device on
the other end of the cable.
(El cable está insertado parcialmente en el puerto o el dis-
positivo en el otro extremo del cable no está funcionando
correctamente.
Por favor verifique el panel anterior de interruptores o
revise el dispositivo ubicado al otro extremo del cable.)
El puerto está desactivado (indicador LED ámbar parpadeando lentamente):
The port was disabled by an administrator manually via the
front panel, or via one of the management tools (El puerto
fue desactivado manualmente por un administrador a través
del panel anterior o a través de una de las herramientas de
administración.)
El puerto tiene un fallo (indicador LED ámbar parpadeando rápidamente):
One or more faulty conditions have occurred:
Laser_Flt: the module is signaling a laser fault (defec-
tive GBIC);
Port_Flt: the port has been marked faulty (defective
GBIC, cable or device)
Diag_Flt: the port failed diagnostics (defective G_Port
card or motherboard)
(Han ocurrido una o más condiciones de fallo:
Laser_Flt: el módulo está indicando un fallo de láser
[GBIC defectuoso];
Port_Flt: el puerto ha sido marcado como defectuoso
[GBIC, cable o dispositivo defectuoso]
Diag_Flt: el puerto falló las pruebas de diagnóstico
[tarjeta G_Port o tarjeta maestra defectuosa])