Users Guide

4-4 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
In addition, six communities and respective trap recipients are supported by the
agent. The first three communities are for read-write (rw) access and the last three
are for read-only (ro) access.
The factory default value for the trap recipient of each community is 0.0.0.0. The fac-
tory default values for the community strings are:
•
Secret C0de
•
OrigEquipMfr
•
private
•
public
•
common
•
Fibre Channel
NOTE: For an SNMP Management Station to receive a trap generated by the agent,
the administrator must configure a trap recipient value to correspond to the Internet
Protocol (IP) address of the Management Station.
agtcfgSet
The
agtcfgSet
command sets the SNMP agent configuration to a Fiber Channel
switch, as shown in the following example. The command fields are described in
Table 4-2.
NOTE: A management platform’s IP address must be configured as a trap recipient to
enable discovery by that management platform. HP OpenView Network Node Man-
ager Special Edition (NNM SE) 3.0 and later have management information base (MIB)
and autodiscovery support for the switch.