Users Guide

support.dell.com PowerVault 51F Commands 4-15
d.
MM
is the minutes
e.
yy
is the year
2. Press <Enter> to set the date and time.
NOTE: The date function does not support daylight savings time. The date must be
reset manually when the time changes.
diagHelp
The
diagHelp
command displays the diagnostic help commands available for trouble-
shooting switch problems. These commands should be run only as advised by Dell
technical support. The following example shows the information that appears when
the command is run
e
errDisplayFilter
The
errDisplayFilter
command allows you to specify the minimum error level to be
reported on the PowerVault 51F switch only. Error level values range from 1 to 5. The
following is example of the
errDisplayFilter
command:
Errors with a level of severity lower than 4 are displayed in the error log.
errDump
The
errDump
command prints the contents of the error log with no page breaks.
switch:admin> diagHelp
ramTest System DRAM diagnostic
portRegTest Port register diagnostic
centralMemoryTest Central memory diagnostic
cmiTest CMI bus connection diagnostic
camTest Quickloop CAM diagnostic
portLoopbackTest Port internal loopback diagnostic
sramRetentionTest SRAM Data Retention diagnostic
cmemRetentionTest Central Mem Data Retention diagostic
crossPortTest Cross-connected port diagnostic
spinSilk Cross-connected line-speed exerciser
diagClearError Clear diag error on specified port
diagDisablePost Disable Power-On-Self-Test
diagEnablePost Enable Power-On-Self-Test
setGbicMode Enable tests only on ports with GBICs
supportShow Print the switch info for debugging
diagShow Print diagnostic status information
switch:admin> errDisplayFilter