Users Guide

support.dell.com PowerVault 51F Commands 4-21
ifShow
The
ifShow
command displays a summary of currently running tasks. The display
includes three sections organized by interface:
ei
— Ethernet 10/100BASE-T port
lo
— Loopback interface
fc
— Fibre Channel; this section is omitted if IP over Fibre Channel is not
configured
ipAddrSet
The following example shows the
ipAddrSet
command, which sets the switchs
Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, Fibre Channel
subnetmask, and gateway address. The fields are described in Table 4-11.
NOTE: Consult your network administrator for the appropriate IP address(es), subnet-
mask(s), and gateway address.
switch:admin> ipAddrSet
Ethernet IP Address [192.168.90.241]:
Ethernet Subnetmask [none]:
Fibre Channel IP Address [192.168.65.241]:
Fibre Channel Subnetmask [none]:
Gateway Address [192.168.90.1]:
Table 4-11. ipAddrSet Command Field Descriptions
Field Description
Ethernet IP address The default IP address on a new switch is a tempo-
rary number derived from the switchs world wide
names (WWN). Enter a valid IP address.
Ethernet subnetmask The Ethernet subnetmask value. The default subnet-
mask value is
none
. See your network administrator
for the appropriate subnetmask value to enter here.
Fibre Channel IP address The Fibre Channel IP address for the switch. Enter a
valid IP address. (Not currently supported.)
Fibre Channel
subnetmask
The Fibre Channel subnetmask for the switch. The
default is
none
.
Gateway IP address The gateway IP address. The default gateway address
on a new switch is
none
. You must enter a valid gate-
way address, if required.