Users Guide

PowerVault™ 50F Commands: Dell™ PowerVault™ 50F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
file:///C|/Users/sharon_anand/Desktop/PowerVault/50f_enit/COMMANDS.HTM[3/15/2013 11:32:02 AM]
Table 7-1. agtcfgShow Command Example
Field Description
sysDescr System description: the default value is set as Fibre Channel Switch
sysLocation The node's physical location. The default setting is End User Premise.
sysContact The identification and contact information for this system. By default, this is set as Field Support
authTraps Trap authentication. Possible values include 0 (OFF), 1 (ON)
SNMPv1
community and
trap recipient
configuration
This example shows six communities available with which to register and define the recipients of SNMP
traps. The recipient is the host, which has SNMP management installed. Values include read and write (rw)
and read only (ro).
swEventTrapLevel Determines the level at which the action of adding an entry to the error log will generate a trap. Possible
values are 0 (OFF), 1, 2, 3, 4, or 5. When set to a valid value above 0, a trap is generated when an entry is
made to the error log at or below the value set. The error log is viewed using the errShow command.
aliasShow
Figure 7-3 shows the aliasShow command, which prints local Alias Server information. If there is no local
alias group, a message stating that is displayed.
Figure 7-3. aliasShow Command Example