Owner manual

Rack Installation Guide 1-1


 !
This document provides instructions for trained service technicians installing one or
more Dell PowerVault 51F Fibre Channel switches in a Dell rack. The switch rack-
mounting hardware includes the following items (see Figure 1-1):
 One switch assembly, consisting of a manifold with an attached bezel, two inner-
slide rails, and the switch
 One slide assembly, consisting of two outer slides, each with a stationary and an
adjustable bracket, and two intermediate slides
 One cable-management arm
 Eight 10-32 x 1/2-inch screws
 Eight tapered washers
The following sections describe the tasks required to install the PowerVault 51F
switch in a Dell rack.
""
Before you install your PowerVault 51F switch in the rack, read the safety information
at the front of this guide and the tool requirement in the following subsection.

To install the PowerVault 51F switch, use a #2 Phillips-head screwdriver and a flathead
screwdriver.
4939tbk1.book Page 1 Friday, October 8, 1999 1:22 PM