Administrator Guide

The AppleTalk protocol is disabled on the NAS system by default. You must enable the AppleTalk protocol for Macintosh clients
to access the NAS system.
To enable the AppleTalk protocol, perform the following steps:
1. Log in to the NAS Manager.
2. Click Shares.
3. Click Sharing Protocols.
4. Click AppleTalk Protocol, and then click Enable.
Disabling the AppleTalk Protocol
To disable the AppleTalk protocol, perform the following steps:
1. Log in to the NAS Manager.
2. Click Shares.
3. Click Sharing Protocols.
4. Click AppleTalk Protocol, and then click Disable.
Configuring the AppleTalk Protocol
To configure the AppleTalk protocol, perform the following steps:
1. Log in to the NAS Manager.
2. Click Shares.
3. Click Sharing Protocols.
4. Click AppleTalk Protocol, and then click Properties.
5. In the AppleTalk Service Properties window, type the logon message the users will see at logon, click the Security
check box if you allow workstations to save passwords and select the type of authentication to be used, and specify the
number of concurrent sessions that are allowed.
6. Click OK to complete the configuration.
Adapter Bindings
FSM can bind to only one network adapter. By default, it is bound to the embedded 10/100TX Network Adapter. To change
the binding in systems with multiple network adapters, the AppleTalk protocol properties for the network adapter to be used
by AppleTalk must be modified to accept inbound connections.
AppleTalk Protocol Adapter Binding
To modify the AppleTalk protocol adapter binding for systems with multiple network adapters, perform the following steps
from the NAS Manager:
1. Log in to the NAS Manager.
2. Click Network.
3. Click Interfaces.
4. Click the radio button next to an enabled adapter to bind the AppleTalk protocol.