Owner manual

Installing the System in the Rack
/t\ CAUTION: If you are installing more than one system, install the first system in
the lowest available position in the rack.
CAUTION: Never pull more than one component out of the rack at a time.
1 Pull the two slide assemblies out of the гаек until they loek in the fully extended
position.
/t\ CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
2 Lift the system into position in front of the extended slides.
3 Plaee one hand on the front-bottom of the system and the other hand on the baek-
bottom of the system.
+ Tilt the baek of the system down while aligning the baek shoulder serews on the sides
of the system with the baek slots on the slide assemblies.
5 Engage the baek shoulder serews into their slots.
6 Lower the front of the system and engage the front and middle shoulder serews in
their slots (the middle slot is just behind the yellow system release lateh) (see
Figure 1-7).
When all shoulder serews are properly seated, the yellow lateh on eaeh slide assembly
elieks and loeks the system into the slide assembly.
7 Press up on the green slide release lateh at the side of eaeh slide to slide the system
eompletely into the raek (see Figure 1-7).
8 Push in and turn the eaptive thumbserews on eaeh side of the front ehassis panel to
seeure the system to the raek.
^ NOTE: Use the yellow system release lateh whenever you wish to remove the
system from the slide assemblies.
1-12 I Rack Installation Guide