Owner manual

Installing the Cable-Management Arm
Q) NOTICE: The cable-management arm can only be Installed on the right side of the
rack cabinet (as viewed from the back).
To install the cable-management arm on the system, perform the following steps:
1 Facing the back of the rack cabinet, locate the latch on the end of the slide assembly.
2 Push the tab on the back end of the cable-management arm into the latch on the end
of the slide assembly (see Figure 1-8).
The latch clicks when locked.
3 Push the tab on the front end of the cable-management arm into a mating latch on
the inner segment of the slide assembly (see Figure 1-8).
The latch clicks when locked.
Figure 1-8. Installing the Cable-Management Arm
latch on end of
slide assembly
latch on inner segment
of slide assembly
tab on front end
tab on back end
cable-management arm
1-1+ I Rack Installation Guide