Owner manual

Figure 1-16. Rotating the Front Mounting Bracket for Flush-Mount
Installation
9
10
the other slide assembly.
Repeat steps C and 5 to eonfigure the other slide assembly.
Holding the left slide assembly into position in the two-post raek at the loeation you
marked, adjust the extended baek braeket tightly against the vertieal two-post raek and
seeure it with three 12-24 x 0.5-ineh pan-head Phillips serews (see Figure 1-17).
Seeure the front braeket on the slide assembly to the two-post rail with two
12-24 x 0.5- ineh pan-head Phillips serews (see Figure 1-17).
Perform steps 7 and 8 to install the right slide assembly in the raek.
Use an 11/32-ineh wreneh or nut driver to fully tighten the nuts on the mounting
braekets on both slide assemblies that you tightened with your fingers.
Rack Installation Guide | 1-25