Owner manual

Installing the System in the Rack
CAUTION: Due to the size and weight of the system, never attempt to install the
system by yourself.
^ NOTE: The procedure for installing a system into a rack is identical for flush-mount
and center-mount slide assemblies.
1 Pull the slides out to their fully extended position.
CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
2 Lift the system into position (see Figure 1-17).
3 Plaee one hand on the front-bottom of the system and the other hand on the baek-
bottom of the system.
+ Tilt the baek of the system down while aligning the baek shoulder serews on the sides
of the system with the baek slots on the slide assemblies.
5 Engage the baek shoulder serews into their slots.
6 Lower the front of the system, and engage the front and middle shoulder serews in
their slots (the middle slot is just behind the yellow system release lateh) (see
Figure 1-17).
When all shoulder serews are properly seated, the yellow lateh on eaeh slide assembly
elieks and loeks the system into the slide assembly.
7 Press up on the green slide release lateh at the side of eaeh slide to slide the system
eompletely into the raek (see Figure 1-17).
8 Push in and turn the eaptive thumbserews on eaeh side of the front ehassis panel to
seeure the system to the raek.
^ NOTE: Use the yellow system release latch whenever you wish to remove the system
from the slide assemblies.
Installing the Cable-Management Arm
See "Installing the Cable-Management Arm" in "Four-Post Raek Installation" found earlier
in this doeument.
Routing Cables
See "Routing Cables" in "Four-Post Raek Installation" found earlier in this doeument.
You have eompleted the installation of the raek kit in a two-post raek.
Rack Installation Guide | 1-27