Owner manual

/К CAUTION: After installing systems in a rack, never pull more than one system
out of the rack on its slide assemblies at one time. The weight of more than one
extended system could cause the rack to tip over and cause injury.
The stabilizer feet help prevent the гаек from tipping over when a system or other
eomponent is pulled out of the raek with the slide assemblies fully extended. Refer to the
doeumentation provided with the raek eabinet for instruetions on installing and anehoring
the stabilizer feet.
Installation Tasks
Installing a raek kit involves performing the following tasks in their numbered order:
Removing the raek doors
Marking the raek
Installing the slide assemblies in the raek:
• RapidRails installation
• VersaRails installation
Installing the system in the raek
Installing the eable-management arm
Routing eables
Replaeing the raek doors
Recommended Tools and Supplies
You may need the following tools and supplies to install the system in a four-post raek:
• A #2 Phillips serewdriver (for installing VersaRails slide assemblies)
• Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
RapidRails Rack Kit Contents
The RapidRails raek kit ineludes the following items (see Figure 1-1):
• One pair of RapidRails slide assemblies
• One eable-management arm
• One status indieator eable
• Tie-wraps
1-4 I Rack Installation Guide