Reference Guide

Note: Before you complete the Backup Exec installation, find the Backup Exec
license keys. These keys are required to complete the installation.
To purchase license keys for additional Backup Exec agents and options, contact
your Dell representative.
To complete the Backup Exec installation by using the Dell™ PowerVault™ DL Backup
to Disk Appliance Configuration Wizard
1
On the Welcome panel, click Next.
2
On the License Agreement panel, read the license agreement, and then click
I accept the terms of the license agreement.
3
Click Next.
4
On the Enter License Keys panel, type a license key into the license key field.
5
Click Add.
6
Repeat steps 4 and 5 for each license key.
7
After you enter all of the license keys, click Next.
8
On the Symantec Backup Exec Options panel, click Next.
9
On the Symantec Backup Exec Services panel, provide a user name, password,
and domain name for the Administrator account that the Backup Exec system
services can use.
10
Click Next.
11
On the Ready to Install the Program panel, click Install.
12
When the Install Wizard Completed panel appears, click Finish.
After the Backup Exec installation finishes, the Dell™ PowerVault™ Backup
to Disk Appliance Configuration Wizard starts the Dell™ PowerVault™ DL
Backup to Disk Appliance Console, from which you can start Backup Exec.
Configuring virtual disks and configuring the Intelligent Disaster
Recovery Option
After the Dell™ PowerVault™ DL Backup to Disk Appliance Configuration Wizard
finishes, you should start Backup Exec and configure the virtual disks. After
Backup Exec configures the virtual disks, you can configure the Intelligent Disaster
Recovery Option.
Installing and configuring Backup Exec by using the Storage Provisioning Option
Completing the Backup Exec installation by using the Dell™ PowerVault™ DL Backup to Disk Appliance Configuration
Wizard
16