Owners Manual

158 Jumpers and Connectors
System Board Connectors
See Figure 6-2 and Table 6-2 for the location and description of system board
connectors.
Table 6-1. System Board Jumper Settings
Jumper Setting Description
1 PWRD_EN
(default)
The password feature is enabled.
The password feature is disabled.
2 NVRAM_CLR
(default)
The configuration settings are
retained at system boot.
The configuration settings are
cleared at the next system boot. (If
the configuration settings become
corrupted to the point where the
system will not boot, install the
jumper and boot the system. Remove
the jumper before restoring the
configuration information.)
NOTE:
For the full name of an abbreviation or acronym used in this table, see the
"Glossary" on page 169.
Book.book Page 158 Monday, September 14, 2009 12:57 PM