Owner's manual

116 Script Commands
Autoconfigure Storage Array Hot Spares
This command automatically defines and configures the hot spares in a
storage array. You can run this command at any time. This command provides
the best hot spare coverage for a storage array.
Syntax
autoConfigure storageArray hotSpares
Parameters
None.
raidLevel RAID level of the disk group that contains
the physical disks in the storage array.
Valid RAID levels are 0, 1, 5 or 6.
diskGroupWidth Number of physical disks in a disk group
in the storage array. For information
about the number of physical disks that
you can use in a disk group, see
"Enclosure Loss Protection" on page 52.
diskGroupCount Number of disk groups in the storage
array. Use integer values.
virtualDisksPerGroupCount Number of equal-capacity virtual disks
per disk group. Use integer values.
hotSpareCount Number of hot spares in the storage array.
Use integer values. For information about
hot spares, see "Assigning Global Hot
Spares" on page 59
.
segmentSize Amount of data (in kilobytes) that the
RAID controller module writes on a single
physical disk in a virtual disk before
writing data on the next physical disk.
Valid values are 8, 16, 32, 64, 128, 256, or
512. For information about the
segmentSize parameter, see "Using the
Auto Configure Command" on page 53.
Parameter Description