Owner's manual

Script Commands 161
Parameters
Reset Storage Array Battery Install Date
This command resets the age of the batteries in a storage array to zero days.
You can reset the batteries for an entire storage array or just the battery for a
specific RAID controller module or in a specific battery pack.
Syntax
reset storageArray batteryInstallDate controller=
(0 | 1)
Parameters
NOTE: If you do not specify a RAID controller module, the age is reset for the
storage array battery or both RAID controller module batteries. If you specify a
RAID controller module, then the age for only that RAID controller module battery is
reset.
Parameter Description
controller RAID controller module to reset. Valid RAID controller
module identifiers are 0 or 1, where 0 is the RAID controller
module on the left and 1 is the RAID controller module on
the right when viewed from the rear of the enclosure. You
must put brackets ([ ]) around the RAID controller module
identifier. If you do not specify an owner, the RAID controller
module firmware returns a syntax error.
Parameter Description
controller Specifies the RAID controller module that contains the
battery for which to reset the age. Valid RAID controller
module identifiers are 0 or 1, where 0 is the RAID controller
module on the left, and 1 is the RAID controller module on
the right when viewed from the rear of the enclosure. Use the
controller parameter only for RAID controller modules with
batteries.