Owner's manual

168 Script Commands
Save Storage Array iSCSI Statistics
This command saves the storage array iSCSI performance statistics to a file.
The following statistics are saved to the file:
• Statistics related to the physical Ethernet port
• Statistics related to the TCP protocol
• Statistics related to the IP protocol
Syntax
save storageArray iscsiStatistics [raw | baseline]
file="
filename "
Parameters
NOTE: If you have not reset the iSCSI baseline statistics since the RAID controller
module start-of-day, the time at the start-of-day is the default baseline time.
NOTE: This command does not automatically append a file extension to the new
file. You must specify the file extension when you enter the file name.
count Specifies the number of events or critical events to save
to a file. If you do not enter a value for the count, all
events or critical events are saved to the file. If you enter
a value for the count, only that number of events or
critical events (starting with the last event entered) are
saved to the file. Use integer values.
Parameter Description
raw This parameter defines that the statistics collected are all statistics from
the RAID controller module start-of-day. Enclose the parameter in square
brackets ([ ]).
baseline This parameter defines that the statistics collected are all statistics from
the time the RAID controller modules were reset to zero using the reset
storageArray iscsiStatsBaseline command. Enclose the parameter in
square brackets ([ ]).
file The name of the file to which you want to save the performance statistics.
Enclose the file name in double quotation marks (" ").
Parameter Description